If you want to make a custom penis mold from scratch, here are some of the best tips and tricks to get started.1.

Don’t use glue, nail polish or plastic, this will make the penis mold more difficult to clean and maintain2.

Do not spray silicone lubricant onto the penis, this can cause the penis to become more difficult for the mold to hold together3.

Don�t mix latex and water, this is the most common source of mold contamination when mold is present4.

You can purchase a silicone mold from a local toy store.

If you don�t have one, the most affordable option is a silicone condom made from a silicone gel that can be used to seal the penis.

It is not always the most expensive option, but you will save money.5.

Do NOT mix wax and water together, this leads to mold growth and can cause an increased chance of contamination6.

Do your research on the product before buying, especially on how it will affect your body, so that you can make a good judgement call about how much mold you want and how much it will cost7.

Use latex gloves to apply silicone to the penis and penis mold as these can also be used for cleaning the mold.8.

Use a silicone-based lubricant such as WD-40, to lubricate the penis for the first few days after mold has been formed9.

Place the penis in a large bowl and pour a small amount of water onto it10.

Wait about 10-15 minutes, then place the penis into the mold and wait until it begins to swell11.

After a couple of days, remove the penis from the mold, rinse it and clean the mold with soap and water.12.

After you remove the mold from the penis you can either keep the penis until it is ready for you to use or use it for your own personal use.